Bar-Tek Upgrade Low Pressure Fuel Pump V3 for TFSI & TSI

The delivery time for products in stock is 1-3 business days.

If the product is not in stock and it is a pre order product, the average delivery time is 5-21 business days. If the product has a longer delivery time than previously announced, we will be in touch.

Terms for product returns:

• You must return the ordered products within 14 days of receiving
• The products must be unused and without damages
• Commission fee for handling returns is 21,90€
• For product returns, the customer is in charge of the return costs. Only door to door service (Express)
• Shipping costs are not refunded

For international orders (outside of Europe) sales are final and non-refundable. Once an order is placed, it cannot be canceled or returned. By placing an order, you acknowledge and agree to these terms.

Return address: QT Parts, Vasarakatu 8B, 37150 Nokia, Finland.

Pre order / made-to-order products

If the product you have ordered is a pre order or made-to-order item, it is not subject to the 14-day right of withdrawal or return under consumer protection laws, as the product is manufactured or sourced specifically based on the customer’s individual order.

If you wish to cancel your order before receiving the product, we will refund 50% of the total order amount.

This condition applies to the following product categories:

• Suspension
• Engine Tuning
• Engine Parts
• Exhaust Systems
• Fueling
• Turbochargers/superchargers
• Drivetrain
• ECE-approved Downpipes

All of the above products are manufactured or sourced individually based on the customer’s order, and therefore cannot be returned after delivery, unless the product has a manufacturing or material defect.

In the event of such a defect, the standard liability for defects as provided by consumer protection legislation shall apply.

Low-pressure upgrade- fuel pump from BAR-TEK® ® for all TFSI & TSI engines now in the V3 RACE version up to 700hp!

The fuel supply in the 2.0 TFSI engine consists of two circuits:

One is the low-pressure system (pump in the tank) and the other is the high-pressure system . The low-pressure pump supplies the high-pressure pump on the engine. With a higher engine output, the low-pressure pump should also be adapted to the higher fuel consumption required in addition to the high-pressure pump. Otherwise, the low pressure may not be sufficient, especially under full load, and the engine may run down. This can result in serious engine damage!

The problem with many replacement pumps on tuned engines is that the engine runs out of fuel for a short time when cornering after ¼ tank of fuel. This can cause the engine to start stuttering or even stall. Some replacement pumps therefore have the problem that the original fuel pump bracket has to be machined. As a result, the pump does not sit deep enough in the tank.

• Pump unit is simply plug & play replaced
• Please choose between front or all-wheel drive
• No further changes necessary, for example to the engine software with standard software!
• Delivery rate at 3 bar / approx. 350 liters per hour

After installation, check the fuel gauge and readjust with VCDS if necessary.

If our pump does not function correctly, please have the software tuner program the pump control (PWM signal) to series!